General Parameters

The general debugging and diagnostic parameters are described in the table below.

General Debugging and Diagnostic Parameters

Parameter

Description

enablesecsyslog

[EnableSecSyslog]

Enables the reporting of security-related events for the data-router networking. When enabled, the data-router access list rules, configured using the access-list CLI command, which are set to "log", send Syslog messages whenever traffic matching the access list is encountered.

■

[0] = (Default) Disabled

■

[1] = Enabled

[LifeLineType]

Defines the condition (i.e., loss of power to the device) upon which the device activates the Lifeline feature for FXS interfaces. When the analog Lifeline is triggered, the device automatically connects a specific FXS port, which is connected to a "lifeline" POTS phone, to the PSTN (or PBX). Therefore, this allows the FXS endpoint user to continue making and receiving calls with the PSTN despite the loss of power.

■

[0] = (Default) Lifeline is activated upon the loss of power to the device, for example, due to a power outage or the unplugging of the device's power cable.

Note:

■

The parameter has only one valid value.

■

For the parameter to take effect, a device reset is required.

■

The parameter is applicable only to the Gateway application and FXS interfaces.

■

If the device is in Lifeline mode and the condition that triggered it (e.g., a power outage) no longer exists (e.g., power returns), the device exits Lifeline mode and performs normal call routing.

■

For information on Lifeline cabling, refer to the Hardware Installation Manual.

'Delay After Reset [sec]'

configure voip > sip-definition advanced-settings > delay-after-reset

[GWAppDelayTime]

Defines the time interval (in seconds) that the device's operation is delayed after a reset.

The valid range is 0 to 45. The default is 7 seconds.

Note: This feature helps overcome connection problems caused by some LAN routers or IP configuration parameters' modifications by a DHCP server.

configure system > hw > usb-power

[UsbPowerCtrl]

Shuts down the USB port(s), by disconnecting power to them.

■

[0] = Off - power disconnected and port shutdown.

■

[1] = (Default) On - power connected and port up.

[EnableAutoRAITransmitBER]

Enables the device to send a remote alarm indication (RAI) when the bit error rate (BER) is greater than 0.001.

■

[0] = Disable (default)

■

[1] = Enable

'Ignore BRI LOS Alarm'

ignore-bri-los-alarm

[IgnoreBRILOSAlarm]

Enables the device to ignore LOS alarms received from the BRI user-side trunk and attempts to make a call (relevant for IP-to-Tel calls).

■

[0] Disable

■

[1] Enable (default)

Note: The parameter is applicable only to BRI interfaces.